Accessmatic accesloop500 Manual De Usuario página 22

accesloop
Relay operation mode channel 1 and 2
When a vehicle enters channel 1 or 2, the relay output of channel 1 or 2 presence signal and presence time could by set by "dip-switches"
# 7 and # 8.
Automatic sensitivity boost
Automatic sensitivity boost causes the sensitivity to be boosted to a maximum detection of a vehicle, irrespective of current sensitivity
level and maintained at this level during the entire presence of the vehicle over the loop.
When the vehicle leaves the loop, and the detection is lost, the sensitivity reverts to the pre selectted level.
Output and LED indicator
Contact relay mode
Without presence of
With the presence of
www.accessmatic.com
500 5242
Relay operating mode
Channel 1 & Channel 2
Permanent presence
Limited presence
ASB
Disabled
Enabled
Status Channel 1 relay
vehicle
vehicle
Dip switch No 7 y 8
Dip No7 On
Dip No8 On
Dip No7 O
Dip No8 O
Dip switch No 6
On
O
Channel 2 relay
Opening your life
7