Waring Commercial QUIK STIK PlUS WSB40ARG Instrucciones De Uso página 6

• In repetitive use applications, frequent cleaning will prolong life.
to wash and sanitize the Quik Stik Plus
1. Rinse the exterior and interior stainless steel portion of the Quik Stik
Plus under running water. Scrub and flush the exterior and interior
™
stainless steel portion to dislodge and remove as much food residue as
possible.
2. Wipe down the exterior of the plastic housing and the stainless steel
portion of the Quik Stik Plus
with the washing solution.
3. Immerse approximately ¾ of the length of the stainless steel portion in
a container of the washing solution and run for two (2) minutes on High.
4. Repeat steps two (2) and three (3) using clean rinse water in place of the
washing solution.
In OrDer tO MInIMIZe tHe POSSIBIlItY Of SCalDInG,
teMPeratUre Of tHe WaSHInG SOlUtIOn anD rInSe
Water MUSt nOt exCeeD 115°f (46°C).
5. Wipe down the exterior of the plastic housing and the stainless steel
portion of the Quik Stik Plus
with the sanitizing solution.
6. Immerse approximately ¾ of the length of the stainless steel portion in a
container of the sanitizing solution and run for two (2) minutes on High.
7. DO nOt rInSe after SanItIZInG IS COMPlete.
Allow to air dry before use.
DO nOt IMMerSe PlaStIC MOtOr HOUSInG In WaSHInG
SOlUtIOn, rInSe Water, Or SanItIZInG SOlUtIOn.
PreVent lIQUID frOM rUnnInG IntO PlaStIC HOUSInG
BY WrInGInG all exCeSS MOIStUre frOM ClOtHS Or
SPOnGeS BefOre USInG tHeM.
6
with a soft cloth or sponge dampened
™
nOte – IMPOrtant
with a soft cloth or sponge dampened
™
nOte
:
™