Domo DO231SR Manual De Instrucciones página 61

www.domo-elektro.be
tap water or distilled water if tap water is too hard.
FILLING YOUR STEAM CLEANER
Important : When there is no more water in the steam cleaner, the steam
will stop.
Step 1 Make sure to remove the plug from the socket before filling the steam cleaner.
Step 2 Screw off the safety fill cap by turning it anti-clockwise.
Step 3 Place the funnel in the fill opening and fill the water tank with 1.2 l water.
Place the safety fill cap back on the unit by turning it clockwise. The heat up time is about
8-10 minutes when you fill with cold water. When you fill with warm water the heat up
time will shorten.
Step 4 Place the plug in an earthed socket of 230V. The red indicator light will
light up.
Step 5 Wait approximately 8 – 10 minutes until the steam reaches the correct tem-
perature and pressure.
Step 6 Attach the accessory you want to use to the flexible tube.
Step 7 In the beginning water will come out of the tube, which is normal. This is
unheated water in the tube.
ATTENTION: Always remove condensation water from the tube before use or when
the appliance hasn't been used for a long time. The tube can be emptied in a container
or in the sink by pressing the button. When the tube is empty it can be used again.
Never direct the tube towards persons, animals or plants.
IMPORTANT: Make sure the plug isn't in the socket when filling the unit for the first
time or when refilling it.
ATTENTION: let the unit cool down for about 15 minutes before refilling it again.
When the unit gets filled when it is still hot the first drops of water can splash out. Be
very careful when opening the safety fill cap: the cap can get hot during use and the
escaping steam can cause burns.
USING THE VARIABLE STEAM FEATURE
Your steam cleaner has a variable steam feature that allows you to adjust the steam
flow to the job you are doing. The variable steam control is located on the handle.
To increase the steam flow, turn the knob counter clockwise.
To decrease the steam flow, turn it clockwise.
REFILLING THE steam cleaner WITH WATER
Step 1
Remove the plug from the socket.
Step 2
Press the steam button and keep it pressed in until all pressure is gone from
the boiler.
Step 3
Unscrew the safety fill cap carefully by turning it counter clockwise, so all
remaining steam can escape. When all hissing has stopped and the last steam has dis-
61
DO231SR