Care And Maintenance - Domo DO231SR Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
www.domo-elektro.be
DO231SR
vapor will not dry out or crack the seals as chemicals often do. Can openers and other
kitchen equipment can be easily cleaned with the detail brush to get into all the nooks
and crannies. Mould stains around door gaskets can be removed with the detail brush.
NOTE : when cleaning small electrical appliances always unplug them from outlet
before cleaning. To clean counter tops, use the floor brush with a terry cloth attached.
For heavily soiled areas, use the brush without the terry cloth towel first in order to
loosen the debris, then follow with a terry cloth attached to finish.
NOTE : Wipe with a towel immediately before the cleaned area dries. When cleaning
the oven, use the detail brush to clean around the elements and drip trays. Use the
detail brush for cracks, crevices and hard to reach areas.
HINTS
The steam cleaner has many uses that have not been mentioned. This was meant only
to give you a general idea of what can be achieved with the unit.It is most helpful to
always have a terry cloth or paper towel ready to use for removal of moisture and res-
idue. 100% white cotton towels work best.You can clean the brushes with your steam
cleaner. To clean the floor brush, hold at one end and use the concentrator to simply
blow off dirt into the garbage can. When cleaning the detail brush, use a pair of pliers
to hold and blow dirt as above or place in the basket of your dishwasher.

CARE AND MAINTENANCE

If you consistently use demineralized or distilled water, cleaning the tank is unneces-
sary.
RINSING OUT THE STEAM CLEANER
Normally, a periodic rinse of your steam cleaner will free it from deposits. This is
recommended every 10 – 15 tankfulls, to free up any scale deposits from the tank.
Fill the boiler with water and shake the cleaner vigorously. Tilt the cleaner upside
down to empty the boiler of water and any scale deposits.
DESCALING YOUR STEAM CLEANER
If the tap water in your area contains a high level of calcium deposits and you have
been using tap water to do your steam cleaning you should descale your unit after 10
– 15 tankfulls.
Step 1 Unplug the steam cleaner from the power source before you descale the
boiler. Allow to cool.
Step 2 Fill the boiler with 1 part vinegar and 4 parts water and leave overnight or
for a period of approximately 8 hours. Do not screw the safety/filler cap onto the
steam cleaner while you are descaling the boiler. Do not use the steam cleaner while
descaling solution is inside the boiler.
Step 3 After the period of soaking, turn the steam cleaner upside down to empty
solution from the boiler. Due to the fact that a small amount of solution will be left
67

Publicidad

Tabla de contenido
loading

Tabla de contenido