Channel Detection; Specifications; Accessory - Toa WT-5810 Instrucciones De Operación

8.4. Channel Detection

Step 1. Press the Set key and the Next key at the same time for over a second.
Channel detection begins, and an idle channel number is indicated blinking on the channel number
display.
Step 2. Press the Next key to select the channel.
Step 3. To set the channel to the unit, press the Set key for over a second until the blinking number turns to
steady light.

9. SPECIFICATIONS

Power Source
Power Consumption
Receiving Frequency
Channel Selectable
Receiving System
Diversity System
Mixing Output
Mixing Input
Antenna
Receiving Sensitivity
Squelch Sensitivity
Squelch System
Tone Frequency
Indicator
Channel Check
Signal to Noise Ratio
Harmonic Distortion
Frequency Response
Operating Temperature
Operating Humidity
Finish
Dimensions
Weight
* 0 dB = 1 V
Note: The design and specifications are subject to change without notice for improvement.

• Accessory

AC adapter ................................................. 1
8
AC mains (Supplied AC adapter must be used)
130 mA (12 V DC)
576 – 865 MHz (576 – 606 MHz and 614 – 698 MHz for USA/Canada)
16 channels
Double super-heterodyne
Space diversity
MIC: –60 dB*, 600 Ω, balanced, XLR-3-32 type connector
LINE: –20 dB*, 600 Ω, unbalanced, phone jack
–20 dB*, 10 kΩ, unbalanced, phone jack
Whip antenna
90 dB or more, Signal to Noise ratio (20 dBμV input, 40 kHz deviation)
16 – 40 dBμV variable
Using together of noise SQ, carrier SQ and tone SQ
32.768 kHz
ANT A/B, Audio (peak), Battery alarm, Channel number
Usable frequencies scanning
104 dB or more (A-weight, unbalanced output)
1% or less (typical)
100 Hz – 15 kHz, ±3 dB
–10°C to +50°C (14°F to 122°F)
30 % to 85 %RH
Resin, black
206 (w) x 40.6 (h) x 152.7 (d) mm (8.11" x 1.6" x 6.01") (excluding antenna)
590 g (1.3 lb)