Equipment Use And Care; Pre-Operation Inspection - RIDGID SeeSnake Standard Manual Del Operador

Equipment Use and Care

• Do not force equipment. Use the correct equipment for
your application. The correct equipment does the job bet-
ter and more safely.
• Do not use equipment if the power switch does not
turn it on and off. Any equipment that cannot be con-
trolled with the power switch is dangerous and must be
repaired.
• Disconnect the plug from the power source and/or
the battery pack from the equipment before making
adjustments, changing accessories, or storing. Pre-
ventive safety measures reduce the risk of injury.
• Store idle equipment out of the reach of children and
do not allow persons unfamiliar with the equipment
or these instructions to operate the equipment. Equip-
ment can be dangerous in the hands of untrained users.
• Maintain equipment. Check for misalignment or binding
of moving parts, missing parts, breakage of parts, and
any other condition that may affect the equipment's op-
eration. If damaged, have the equipment repaired before
use. Many accidents are caused by poorly maintained
equipment.
• Do not overreach. Keep proper footing and balance at
all times. This enables better control of the equipment in
unexpected situations.
• Use the equipment and accessories in accordance
with these instructions, taking into account the work-
ing conditions and the work to be performed. Use of
the equipment for operations different from those intend-
ed can result in hazardous situations.
• Use only accessories that are recommended by the
manufacturer for your equipment. Accessories that
may be suitable for one piece of equipment may become
hazardous when used with other equipment.
• Keep handles dry, clean, and free from oil and grease.
Clean handles give better control of the equipment.
Find Quality Products Online at:
GlobalTestSupply
www.

Pre-Operation Inspection

WARNING
To reduce the risk of serious injury from electrical
shock or other causes, and to prevent damage to your
equipment, inspect all equipment and correct any prob-
lems before each use.
To inspect all equipment, follow these steps:
1. Power off your equipment.
2. Disconnect and inspect all cords, cables, and connec-
tors for damage or modification.
3. Clean any dirt, oil, or other contamination from your
equipment to ease inspection and to prevent it from
slipping from your grip during transport or use.
4. Inspect your equipment for any broken, worn, missing,
misaligned, or binding parts, or any other condition
which might prevent safe, normal operation.
5. Refer to the instructions for all other equipment to in-
spect and make sure it is in good, usable condition.
6. Check your work area for the following:
• Adequate lighting.
• The presence of flammable liquids, vapors, or dust
that may ignite. If present, do not work in area until
sources have been identified and corrected. The
equipment is not explosion proof. Electrical con-
nections can cause sparks.
• A clear, level, stable, and dry place for the operator.
Do not use the equipment while standing in water.
7. Examine the job to be done and determine the correct
equipment for the task.
8. Observe the work area and erect barriers as neces-
sary to keep bystanders away.
See additional product specific safety information and
warnings starting on page 8.
SeeSnake Standard – English – 5
.com
sales@GlobalTestSupply.com