[En] - ratiotec CS 50 Manual De Instrucciones

[EN]

Coin counting
1. Switch on machine and wait until the self-test is complete and 0.00 appears in the display.
2. Feed the coins into the coin funnel.
3. Press the START/STOP key to start the counting process.
4. Press the START/STOP key again to stop the counting process. The machine automatically switches itself
off after 20 seconds without coin infeed. The sum total in Euro is shown in the display.
5. In order to view the number of individual coin types, press the Report key.
6. Use the C key to return to the counting result.
7. In order to continue with the counting process, feed in more coins and press the START/STOP key.
8. The machine stops automatically if a coin container is full.
9. In order to start a new count, empty the coin container and reset the counter to 0.00 using the C key.
Batch mode
When the Set key is pressed, the preset number for the individual coin types is displayed.
Default settings:
Use the +/- keys to increase or decrease the respective preset numbers in steps of 1. The Bat key can be used to change
the respective preset quantity in larger steps. If one of the preset quantities is attained during a counting process, the
machine stops automatically and shows which coin type is affected and how many coins are situated in the respective
tray. Remove the coins from the affected tray and continue with the counting process by pressing the START/STOP key.
Print counting results
By pressing the PRINT key an overview of the counting results will be printed through the printer connected
( Buad 1200) . The receipt shows the quantity and value for each denomination, the total quantity and total value.
Troubleshooting
Should a coin get stuck in a coin duct, switch off the machine. Pull the power plug and remove the remaining
coins from the machine. Remove the stuck coins by hand or with another suitable object by reaching into the coin
duct from below.
Error messages
The following error messages could appear on the display following the self-test after the machine is switched on.
EC – Rotary disc error/no rotation
E0 – Coin recognition error
E1 – E8 – Sensor error for the respective slot number counted from the right.
4
€ 2 – 80 € 0,50 – 80
€ 1 – 80 € 0,20 – 110
€ 0,10 – 110 € 0,02 – 150
€ 0,05 – 110 € 0,01 – 150