Packing List; Assembly - Power Stroke PS21ESLM Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-877-617-3501 for assistance.

PACKING LIST

Lawn Mower with Mulching Plug
Start Key
Side Discharge Deflector
Grass Catcher
Handle Mounting Hardware
Battery Charger/Maintainer
Garden Hose Quick Connect Coupler
4-Cycle Lubricant
Operator's Manual
WARNING:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.

ASSEMBLY

WARNING:
Do not insert start key until assembly is complete and
you are ready to mow. Failure to comply could result in
accidental starting and possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
WARNING:
Never operate the mower without the proper safety
devices, guards, and deflectors in place and working.
Never operate the mower with damaged safety devices.
Operating the mower with missing or damaged parts can
result in serious personal injury.
UNFOLDING AND ADJUSTING HANDLE
ASSEMBLY
See Figure 2 - 3.
 Pull up and back on the lower handle until the holes on
the lower handle and mounting bracket are aligned.
NOTE: Choose the hole position that corresponds to the
handle angle desired.
 Insert bolt through holes with the threaded end facing in.
 Install the washer and handle knob and tighten securely
to secure the bolt in place.
 Repeat on the opposite side to secure the lower handle
in place.
 Pull up on the upper handle to raise it into operating
position. Make sure that the lower handle is seated in
the grooves at the bottom of the upper handle.
NOTICE:
Do not allow the starter cable to become pinched or
trapped when raising the handle.
 To secure the upper handle in place, securely tighten the
handle knobs.
 Route the the starter grip and rope up to and through the
rope guide on the upper handle as shown.
 To lower the handle assembly, loosen the handle knobs
and fold the handle to the front of the unit. Avoid pinching
or trapping any cables.
Page 7 — English