Battery Change - iTEC iViewer 02 HD Manual De Instrucciones

ADVANCED MECHATRONIC SOLUTIONS
controlo de acessos | access control | control de acceso | contrôle d'accès
iViewer 02 HD®

battery change

1. Slide the lid upwards and open outwards as shown in diagram.
2. Put in the batteries according to the "+" "-" sign on the lid.
3. Take the reverse steps to close the lid.
Attention:
1. DO NOT force when opening and closing the lid to avoid damaging the lid.
2. DO NOT press the lid to the opposite direction when open to avoid any lid damage.
3. When the low battery indicator is on, please replace all batteries to avoid any damage to this product by
battery weeping.
No Power
Full Power
The battery icon shows the power state. When the power is reducing, the bars in the icon will reduce. But as for
some dry batteries or rechargeable batteries, the power state in the icon could be unstable, which is normal.
When the batteries run out, this icon will be in blank, which indicates the user to replace the batteries. The
following types of batteries can be used in this product: AA, LR03 1.5V alkaline battery. Any abandoned batte-
ries should be disposed according to local environment protection rules and regulations.
12
www.itec.com.pt