Auto-Power Off Setting - iTEC iViewer 02 HD Manual De Instrucciones

13 | 03 | 2020
iViewer 02 HD®
operations
Memory Card Installation:
- Please insert the memory card before installing the batteries.
- Before inserting the memory card make sure the marked side is facing the back, when you hear a click the
card is locked and correctly.
- This product will take a max. 16GB SD memory card.
- To remove the memory card: press the card and it will pop out approximately one third, you can then remove
the card.
- This product supports hot plugging.
System time and date setting:
- Please set the system date and time after installing the batteries.
- Press menu button, shift the selection key to "Date Setting", and press menu button to enter.
- After entering the "Date Setting" menu, press menu button again to select the digit to be set and use"
▲▼"to adjust the number.
- If you want to add date and time information on the photos, you can choose the "Time & Date Display" -ON,
otherwise choose OFF.

Auto-power off setting:

- This product has user-defined setting for auto-power off.
- If you need to change the default setting, please press "menu" button, thenchoose the "auto-power off " and
press "menu" button to enter. There are 4 options to choose in this menu: 10S/20S/30S/NEVER.
- 20S is the default mode.
- NEVER mode is for customers with special needs. Caution: in this mode the screen will stay on until manually
turned off, if not turned off, the batteries will quickly run out of power.
Visitors:
- When visitors press the door bell button on the door viewer camera, the door bell will ring inside of the
room.
- At the same time, the screen inside the door will turn on automatically to show the outside images and will
last for 20seconds before turning itself off.
- Also as the door bell is pressed, the camera will automatically take a photo of the visitors and the photo will
be stored in the SD card in case the host is out, so as to check the visitors' identity or to use the information
for security purposes.
To view outside:
- Press the power button, an image of the exterior will be shown on the screen.
- The screen will automatically power off after 20 seconds with no other operations.
- After turning on the product, press on the power button again and the product will be turned off.
To check outside and take photos or videos:
- When viewing outside with this product, photos or videos can be taken at the same time.
- When the screen is on, press "▼" to take a photo.
- To take a video, press the "▲" and hold till the instruction icon " " appears to switch into video taking
mode and press"▼ "to start shooting, one more press of "▼"will end the video taking.
- All videos taken have no sound.
15
www.itec.com.pt