Publicidad
Idiomas disponibles
Idiomas disponibles
Enable (ON) or disable (OFF) the subsonic filter at 50 Hz by means of the jumper marked with nr.4. We recommend to
enable the filter in all the cases except when using 12'' or bigger speakers.
ATTENTION: Essential to place this jumper in ON or OFF. If it were not put this jumper, the module would not work
correctly.
Insert and screw the module and the chassis together in the front and back panels.
Connect the data buses (Flat 10- and 20-way cables) to the connectors marked with nr.5 in the figure on next page.
Connect the power supply cable to the amplifiers marked with nr.6 on the figure on next page.
Link together the front and back panel. In this case you will have to connect following connector pair marked with nr.7:
J121-J101.
Once the complete installation of one or various chassis and the peripherals connections to ENVIRO has been carried out,
you should adjust the BGM, BGA and PAGE volume controls and finally adjust the BGM attenuation as the final step in this
modules configuration.
ATTENTION: These power modules must be adequately cooled, so don't cover the up and back air-cooling system grill of
the chassis.
ATTENTION: In order to connect and to disconnect these modules, we must make sure always, that the power supply
MPS240 is unloaded, to avoid possible unloadings in the modules. In order to unload the source, to extinguish the MPS240
and to wait for 2 minutes.
MP30/MP60/MP120 MODULE
MP30/MP60/MP120
2/2
7
6
3
1
2
4
www.audiovias.com
5
50.0039.01.00
Publicidad
