VOSS.farming BA-1262 Manual De Instrucciones página 4

Specific Operating Instructions
This completely new designed, High-Performance-Fence-Energizer owns an intelligent POWERtronic-technology,
which gives you the possibility of an automatic power-adaptation of your fence-system. POWERtronic achieves excellent
fencing security with minimal current consumption and offers unique and maximimal flexibility and a variety of
combinations of power sources, such as 12V, 9V, 12+solar, 9V+solar and mains supply. Of course the solar-charge-
regulator is already integrated with POWERtronic.
POWERtronic - the future-orientated technology - is already available to you today.
a.)
2
9
1
c.)
Operating modes:

On- / Off switch: Press operating knob (2) as long (approx. 3sec.) as
Display

By turning the operation knob the display goes into the adjustment-mode, the power-levels can now be adjusted

The actual voltage of the current-source is shown by short pressing of the operating knob during the OFF-
condition or during normal operation.
Possible current-sources:
- 12 Volt (approx.80-85Ah) accumulator (ideal value: 12,6 – 13,8V)
- 9 Volt (175Ah) „Alcaline"-battery (ideal value: 7.8 - 9V, during the current operation!)
Optional additionally with solar-modules possible ( max. 50W solar-module
- special 230 Volt mains-adapter No. 371012 (keeps charging status but not suitable for recharging the 12V
accumulator)
LCD-display (5)
Adjustment-mode
Mains adapter resp.
Solar-module supplies current
b.) Starting the appliance without fence and earth connection:
General:
The appliance is opened by mutual opening of the closing-tabs (8).
Close the appliance solidly before a new start. Operate only in up standing position; see above picture (b).
12V / 9V - operation
Always connect first the enclosed 12V - or 9V - connection cable to the battery or the accumulator. Pay attention on
correct polarity (red + and black -) when connecting the battery or the accumulator. Than put the battery or the
accumulator into the housing, lead the ventilation tube of the accumulator (if existing) outside through the gap! Now
connect the plug of the connection cable with the plug (9) at the top casing. Start the appliance by longer pressing
(approximately 3sec.) of the operating knob (2) without fence and earth.
If the fence voltage indicator light (4) flashes green and a voltage of higher 4kV is indicated on the display, the appliance
is ready to start. If the battery indicator light (3) flashes red additionally, then the battery should be recharged soon resp.
being replaced soon. If only the battery indicator light (3) flashes red and the indicated fence-voltage is 0.0, this means
that the battery has to be changed resp. the accumulator has to be recharged without any delay. If none of the indicator
lights is blinking and no value is indicated on the display, first check the polarity of the connection cable at the current-
source resp. contact your expert for a check.
In case of operation with a solar-module / mains adapter (see below b.) the accumulator / battery should always be
connected, before the solar-module / mains adapter is connected to the solar-socket (otherwise the danger of a short
circuit exists). Before connecting to the fence, switch OFF the appliance with the operating knob (2) and switch ON only
after connection again.
4 b.)
3
5
This energizer shall not be used as an
animal trainer (inside a barn).
7
6
: power-levels
12V: 1 to 20
9V: 1 to 5
1
8
2
3
4
5
6
7
8
9
Display-mode:
Voltage of accumulator / battery
V
7.7
Display-
kV
Display-mode:
Exit-voltage in kV
7,7kV = 7700 Volt
4
NOVAS 6
Solar / 230V mains adapter
connection
Operating knob continuously
adjustable power control
Battery indicator light
Fence voltage
indicator light
LCD - display
Earth connection
Fence connection
Closing-tabs
(for closing / to shut cover and
housing)
Plug for battery cable
kV appears right below on the LCD -
connection (1) )
-EN-
Version : 2019.1