3. BATTERY
SPECIFICATIONS
BT 48 Li 2.0
Battery: 48V Max, 96Wh
Voltage per cell: 3.6V ; Number of cells: 12
Charge time: 90 min (use CG 48 Li Charger)
Charge time: 30 min (use CGF 48 Li Charger)
BT 48 Li 2.5
Battery: 48V Max, 120Wh
Voltage per cell: 3.6V ; Number of cells: 12
Charge time: 120 min (use CG 48 Li Charger)
Charge time: 38 min (use CGF 48 Li Charger)
BT 48 Li 4.0
Battery: 48V Max, 192Wh
Voltage per cell: 3.6V ; Number of cells: 24
Charge time: 180 min (use CG 48 Li Charger)
Charge time: 60 min (use CGF 48 Li Charger)
BT 48 Li 5.0
Battery: 48V Max, 240Wh
Voltage per cell: 3.6V ; Number of cells: 24
Charge time: 240 min (use CG 48 Li Charger)
Charge time: 75 min (use CGF 48 Li Charger)
For the proper use, maintenance
and storage of this
battery, it is crucially important that you read and
understand the instructions given in this manual.
To avoid serious injury, risk of
fire, explosion and danger
of electric shock or electrocution:
• DO NOT probe the charger with conductive
materials.The charging terminals hold 120 V.
• If the battery pack case is cracked or
damaged, DO NOT insert into the charger.
Replace witha new battery pack.
• DO NOT charge these battery packs
with any other type of charger.
• DO NOT allow liquid inside the charger.
• DO NOT try to use the charger for any other
purpose than what is presented in this manual.
• DO NOT try to short circuit any
terminals of battery pack.
•
If the battery fluid gets in
your eyes, flush immediately
with clean water for at least 15 minutes.
Get immediate medical attention. Do not
charge the battery pack in rain or in wet
conditions. Do not immerse the tool, battery
pack, or charger in water or other liquid.
• Do not allow the battery pack or charger to
overheat. If they are warm, allow them to cool
down. Recharge only at room temperature.
• Do not cover the ventilation slots on the
top of the charger. Do not set the charger
on a soft surface i.e. blanket, pillow. Keep
the ventilation slots of the charger clear.
• Do not allow small metal items or material
such as steel wool, aluminum foil, or other
foreign particles into the charger cavity.
• Unplug the charger before cleaning and when
there is no battery pack in the charger.
• Do not place the battery pack in the
sun or in a warm environment. Keep
at normal room temperature.
• Do not try to connect two chargers together.
• Keep in shady, cool and dry condition, if the
battery is not charged for a long time; charge
the battery for 2 hours every 2 months.
• The battery pack cells may develop a small
leak under extreme usage or temperature
conditions. If the outer seal is broken
and the leakage gets on your skin:
• Use soap and water to wash immediately.
• Neutralize with lemon juice,
vinegar, or other mild acid.
• If leakage gets in your eyes, follow instructions
above and seek medical attention.
• Please check prior use, if output voltage
and current of the battery charger is
suitable for the charging battery pack.
• Do not use the charger in the
circumstances that the output Polarity
does not match the load polarity.
• For indoor use only.
• The cover may under no circumstances
be opened. If the cover is damaged, then
the charger may no longer be used.
• Do not recharging non-rechargeable batteries.
CHECKING BATTERY CAPACITY
Press the battery capacity indicator (BCI)
button. The lights will illuminate according to
the batteries capacity
Lights
4 Green
Lights
3 Green
Lights
EN - 2
level. See chart below:
LIGHT
METRE
Capacity
The battery is at full capacity
The battery is at 70% capacity
BATTERY
METRE