Dometic Waeco PerfectView M5L Instrucciones De Montaje página 30

_M5L_M7L_M7LX.book Seite 30 Donnerstag, 14. Januar 2010 3:03 15
Mounting the LCD monitor
Check beforehand that there is sufficient room for the drill head to come out on
the other side (fig. 2, page 3).
Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
Ensure that you can lay the connection cables to the monitor.
Choosing the installation location
Place the monitor and the mounting rail on the monitor bracket (fig. a A,
page 6).
Place the monitor bracket and the mounting rail onto the support base and
secure it using the knurled nuts (fig. a B, page 6).
Position the monitor and the attached monitor bracket provisionally.
Mark the outlines of the corners of the support base on the dashboard.
Unscrew the support base from the monitor holder.
NOTE
I
You can fasten the support base using adhesive or screws.
Sticking the monitor bracket onto the dashboard (fig. b A, page 6)
Remove the film from under the support base.
Stick the support base to the position of your choice.
Screwing the monitor bracket onto the dashboard (fig. b B, page 6)
Hold the support base within the outlines marked beforehand.
Mark four different drilling points.
Drill a hole of ∅ 2 mm at each of the points marked beforehand.
Screw the support base on using 4 x 20 mm self-tapping screws.
Fastening the monitor
Place the monitor and the mounting rail onto the support base and secure it
using the knurled nuts (fig. a, page 6).
30
PerfectView M5L, M7L, M7LX