Twin-Star International 23MM1297 Manual De Instrucciones página 6

2. Locate Hearth/Base (A) and set out fi nished side up
on the fl oor.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Attach the Completed assembly from step 1 to the
Hearth/Base (A). Make sure that dowels are seated
into the pre-drilled holes in the Hearth/Base. Using
Bolts (AA) and Washers (BB) attach panels through
pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Insert one Wood Dowel (CC) into each of pre-drilled
holes. Push the Right Side Panel (F) and Left Side
Panel (E) snug to completed assembly. Using Bolts
(AA) and Washers (BB) through the pre-drilled holes
in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA
Bolt
BB
Washer
CC
Wood Dowel
3. Connect the plugs of Light Pucks (K-1) to the
outlets wired to the Appliance Control Box (K-2).
Drape the Light Pucks (K-1) with long wire over the
Center Shelf (P) and secure wire, using Wire Clips
(II) and Screw (FF,GG). The light kit is now ready to
be plugged in to the power source. Touching the
Touch Switch (JJ) will turn on or off the lights.
Hardware Used
FF Screw
GG
Screw
II
Wire Clip
Touch Switch
JJ
(J-1,J-2)
4. Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Locate the Center Shelf (P) on the top of the
assembly from the step 3, as shown in diagram.
Make sure that dowels are seated into the pre-drilled
holes.
Using Bolts (AA) and Washers (BB) attach these
panels through pre-drilled holes in the mounting
blocks.
HAND TIGHTEN ONLY.
Push Support Panel (K) snug to the Center Shelf (P),
tighten Bolt (AA) and Washer (BB) through the
pre-drilled holes.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
Fig. 2
F
x 8
Fig. 3
x 8
x 8
x 12
x 2
x 8
x 1
Fig. 4
CC
x 11
x 11
x 8
5
AA
BB
A
CC
GG
P
K
P
BB
AA
E
CC
FF
K-1 K-1
K-2
JJ
FF
II
CC