Twin-Star International 23MM1297 Manual De Instrucciones página 8

8. Locate Right Front Door (M) and Left Front Door (L).
Slide door hinge keyhole into panel hinge bracket.
(Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change keyhole
slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (DD) to the Left Front Door (L) and
Right Front Door (M), use the bolts attached through
the pre-drilled holes in the doors. Then use a Phillips
Head Screwdriver to tighten the bolts.
Hardware Used
DD
Knob
9. Choose desired height of Glass Shelf (H) and place
the four Shelf Pin (HH) into same height shelf holes
inside side panels. Insert Glass Shelf (H), allow
Wood Shelf (H) to rest on the Shelf Pin (HH).
Hardware Used
HH
Shelf Pin
10. PLEASE READ ALL "ELECTRIC FIREPLACE
INSERT" INSTRUCTIONS PRIOR TO
INSTALLING ELECTRIC INSERT IN YOUR
COMPLETED FIREPLACE MANTEL. INSTALL
THE INSERT IN YOUR FIREPLACE CLOSE TO
ITS FINAL POSITION.
Lift insert carefully into the back of the unit and
center in the insert opening. Do not drag insert
across hearth/base as it may scratch the unit.
Connect the Insert Support Bar (Q) to the inside left
and right panels, using the bolt (AA) and washer
(BB) through pre-drilled holes.
MOVE YOUR COMPLETED UNIT ONLY SHORT
DISTANCES. MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO PEOPLE TO
MOVE COMPLETED UNIT INTO ITS FINAL
POSITION.
Hardware Used
AA
Bolt
BB
Washer
Fig. 8
L
x 2
Fig. 9
x 8
Fig. 10
Completed
Unit
x 2
x 2
7
M
H
HH
Install
Insert
From
Back
Electric
Fireplace Insert
Q
AA BB
DD