System Specifications - Kinetico A200 Manual Del Usuario

A200 Drinking Water Sytem

System Specifications

TDS ppm maximum level: 3000
pH Range: 3–11
Pressure Ranges: 35–100 psi/241.3–689.5 kPa
Temperature Range: 35–100°F / 2–38°C
Discharge Water/Product Water Ratio: 6 to 1
Rated Service Flow: 1.0 gpm (4.5 Lpm)
Rated Filter Capacity (postfilter): 500 gal (1892.7 L)
Typical Daily Production Rate: 10.9 gpd (41.3 L)
Maximum Daily Production Rate: 30 gpd* (113.5 L)
*Manufacturer' s calculated max. rate with open storage tank, ideal inlet water pressure of 100 psi, temperature
of 98°F and 100 ppm TDS conditions.
A200 Drinking Water Systems are tested and certified by NSF International against
42 for the reduction of aesthetic chlorine, taste and odor.
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts.
This system shall only be used for arsenic reduction on chlorinated water supplies containing
detectable residual free chlorine at the system inlet. Water systems using an in-line chlorinator should
provide a one minute chlorine contact time before the RO system.
12
the requirements of NSF/ANSI Standard 58 for the reduction of arsenic, barium,
cadmium, copper, cysts (including cryptosporidium, giardia, toxoplasma and
entamoeba oocysts), flouride, hexavalent chromium, lead, radium 226/228, selenium,
total dissolved solids, trivalent chromium and turbidity, and NSF/ANSI Standard