JollyLine MGR030 Manual De Instrucciones página 4

P1
INSTRUCTION MANUAL
The radio control units included in the pack are already programmed and ready to use.
Zones 1 and 2 can operate independently in bistable or timed mode.
SETTING THE MODE OF OPERATION:
ZONE1
BISTABLE: remove the jumper on terminals 1 and 2
TIMED: insert the jumper on terminals 1 and 2
ZONE2
BISTABLE: remove the jumper on terminals 2 and 3
TIMED: insert the jumper on terminals 2 and 3
RADIO CONTROL ACQUISITION:
ZONE1
1. Press key P1 on the control unit once to program exit Z1; the LED will remain on.
2. Press and hold the key to be acquired on the radio control unit until the LED on the
main control unit starts to flash; release the key.
ZONE2
1. Press key P1 on the control unit twice to program exit Z2; the LED will remain on.
2. Press and hold the key to be acquired on the radio control unit until the LED starts to
flash; release the key.
SETTING THE WORK TIME (time the exit is on - programmable up to a maximum of
4 '30 ")
Only if TIMED MODE is used
ZONE1
Press key P2 on the main control unit once to set the work time for exit Z1, the LED will
come on.
Wait a length of time equal to the WORK TIME to be set on exit Z1, after which press key
P2 again.
The LED will flash three times to confirm.
ENGLISH
FUSE 5A
R1 R2
P2
1 2 2 3
LED
4
F
IN 230V ac
N
N2
Z2
OUT 230V ac
N1
Z1
PZ2
COM
PZ1
GND
ANTENNA
ANT