Declaration Of Conformity - JollyLine MGR030 Manual De Instrucciones

ZONE2
Press key P2 on the main control unit twice to set the work time for exit Z2, the LED will
come on.
Wait a length of time equal to the WORK TIME to be set on exit Z2, after which press key
P2 again.
DELETING THE RADIO CONTROL CODES:
Deleting an individual code:
Press and hold key P1 on the main control unit for 5 seconds (release the key); the LED will
remain on. Press the key on the radio control unit to be cancelled until the LED begins to
Deleting all codes:
Press and hold key P1 on the main control unit for approx. 10 seconds, the LED will come
codes.

DECLARATION OF CONFORMITY

G.B.S. Elettronica srl
Declares that: the Black Easy Light device,
• is manufactured for the remote control of external electrical devices;
• The product complies with essential requirements of Directive
Documentation kept at: G.B.S. Elettronica srl
Notes for installation
WARNING! It is important the following manual be followed for safety reasons. Incorrect
installation or improper use of the product can lead to severe damage to property and/
or persons.
• The packaging materials should be kept out of the reach of children since they are
potentially hazardous.
• G.B.S. Elettronica declines all responsibility resulting from improper use or any use other
than that indicated in this documentation.
• Do not modify the device in any way.
• Disconnect the power supply prior to any intervention on the system.
• Fit a bipolar switch to the device power supply (Use of a magnetothermal device with
omnipolar switching is recommended).
device.
or fumes constitutes a serious safety hazard.
• Anything not expressly envisaged in these instructions is not permitted.
•Store the instructions for future reference.
HAZARD
Ensure the device is not connected to the power supply before opening the cover hatch on
the casing in which it is contained.
THE INFORMATION CONTAINED IN THIS INSTALLATION MANUAL MAY BE SUBJECT TO
CHANGE WITHOUT PRIOR WARNING.
5
2014/53/UE.