General Safety Rules - CEVIK CE-PE400S Manual De Instrucciones

EN
GENERAL SAFETY GUIDELINES.
WARNING: Read and understand this manual before using this product. Failure to do so
can result in serious injury.
WORKING AREA.
•
Keep working area clean and well lit. Cluttered areas and benches invites accidents.
•
Do not use welding helmet into explosive atmospheres or in the presence of flammable
liquids, gases or dust. Electric arc welding process generates sparks that may cause fires.
•
Keep observers, childs and visitors away from working área. Distractions may cause a
loss of control.
ELECTRICAL SAFETY.
WARNING:
•
Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges
and refrigerators, there is an increased risk of electrical shock.
•
Do not expose the product to rain or moisture. Water ingress into electronic elements
will increase the risk of protect fault and electrical shock.
PERSONAL SAFETY.
•
Stay alert, look what you are doing and use common sense when wearing welding
helmet. Do not use welding helmet if you are tired or under the influence of alcohol,
drugs and medication. A moment of distraction can result in serious injury to the eyes.
•
Dress properly. Do not wear loose clothing or jewelry which may get caught in moving
parts.
•
Avoid work positions that could expose unprotected areas of the body to spark, spatter,
direct and7or reflected radiations. Use adequate protection if exposure cannot be
avoided.
BEFORE WELDING.
•
Check the front cover lens to make sure they are clean, and no dirt is covering the sensor
on the front of filter cartridge.
•
Check the front/inside cover lens and the front lens retaining frame to make sure that
they are secure.
•
Inspect all operating parts before each use for signs of wear or damage. Any scratched,
cracked or pitted parts should be replaced immediately before using again to avoid
severe personal injury.
•
Check for light tightness before each use.
SAVE THIS MANUAL.
16