Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
12.
Secure the chute elbow to the tractor's deck by hooking
the chute strap onto the ball pin installed earlier on the
deck. See Figure 4-24.
Figure 4-24
13.
Install the chute adapter onto the chute elbow by lining up
the tabs and sliding the adapter over the chute elbow, as in
Figure 4-25. Secure the chute adapter by installing the two
ratchet clips included in the hardware pack in the holes
provided.
Figure 4-25
NOTE: Check the upper chute for a cardboard insert
installed for shipping purposes. If the insert is present,
remove it before continuing with Step 14.
14.
Peel the backing off of the self-adhesive foam strip (721-
04388) that has been included with your grass collector.
Apply it to the upper chute, flush against the flange as
shown in Figure 4-26.
Flange
Figure 4-26
15.
With the bagger cover open, install the upper chute over
the chute adapter, and rest the top so that the chute
support sits in the upper chute groove. See Figure 4-27.
NOTE: Make sure to align the upper chute with the ridges
on the bagger support bracket.
S
ection
4 — A
& i
SSembly
nStAllAtion
15
Publicidad
Capítulos
Tabla de contenido
