Fender PD250 PLUS Instrucciones De Funcionamiento página 14

Set-up aNd coNNectIoNS
PoWER ToWER ™
In setting up the system, the Passport Mixing
console should ideally be placed where system
performance can be evaluated by the operator.
If no ongoing adjustments will be necessary, the
mixer may be placed conveniently and where the
cable lengths allow.
Take care to place the Power Tower where the
cables will not trip anyone. All cables should be
carefully secured.
The storage compartment in the rear of the
Tower can hold cables, microphones and other
system parts. To open simply slide the catch
upwards and pull open.
The mains (AC) fuse holder is under the IEC
(power cord) socket on the right rear of the
Tower. To change a fuse, remove the IEC plug
and, using an appropriate tool pull out the fuse
holder. Note there is a spare fuse in the fuse
holder; the Passport utilizes a T6.3AH, 250V fuse.
Only replace fuses with one of an identical value
and size.
The Passport System is weather resistant in
its packed transport mode. However, when
operating outdoors, take care to fully protect the
Power Tower in the event of exposure to rain.
Remember to allow free air flow through the
air inlet located at the bottom of the rear
panel on the Passport power tower.
SpecIfIcatIoNS
Part Number
Frequency Response
Distortion
System Signal to Noise Ratio
Power Output
Input Impedance
(Channels 1-2-3-4 XLR and 1/4")
(Phono and Stereo Channel 1/4")
Max. Input Level
Return Input Impedance
Fuse type
Passport System
Speakers
Power Tower
Tower Footprint
Microphone
Microphone Cable
Speaker Cables
14
069-3001-000 PD-250+ 120V US
069-3001-900 PD-250+ 120V DS
069-3001-930 PD-250+ 240V AUS
069-3001-940 PD-250+ 230V UK
069-3001-960 PD-250+ 230V EUR
069-3001-970 PD-250+ 100V JPN
50 Hz to 30 kHz ± 1 dB (at speaker output)
30 Hz to 20 kHz ± 1 dB (at send output)
< 0.5% 20 Hz to 20 kHz (at speaker output)
< 0.1% 20 Hz to 20 kHz (at send output)
> 85 dB, "A" WTD
250 W (125 W/ch @ 8ohm per channel)
"Mic" switch position: 2 k ohm
"Line" switch position: 66 k ohm
78 k ohm
Mic: -11 dBu
Line: 20 dBu
Stereo: 26 dBu
47k ohm
T6.3AH, 250V
Width: 840 mm (33.7 in.)
Height: 615 mm (24.2 in.)
Depth: 300 mm (11.8 in.)
Weight: 24 kgs (53 lbs)
Width: 300 mm (13.4 in.)
Height: 610 mm (24.2 in.)
Depth: 300 mm (11.8 in.)
Weight: 7.3 kgs (16 lbs)
Width 185 mm (7.3 in.)
Height 615 mm (24.2 in.)
Depth 300 mm (11.8 in.)
Weight 9.5 kgs (21 lbs)
350 x 300 mm (9.5 x 11.75 in.)
Dynamic Cardioid, balanced
XL -Male to XL-Female, 6 m (20 feet)
1/4 in. to 1/4 in., 9 m (27 feet)
0 dBu is referenced to 0.775 volts rms