Important Safety Instructions; Basic Setup - Fellowes AutoMax 100M Guia De Inicio Rapido

A.
B.
C.
D.
E.
F.
CAPABILITIES
Will shred: Paper, plastic credit cards*, staples* and small paper clips*
*Manual Feed
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Micro-Cut .................................................................5/32 in. x 25/64 in. (4mm x 10mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
instruction manual. Read the entire instruction manual before operating
shredders.
Always set to off or unplug when not in use.
shredder openings. If object enters top opening, switch to Reverse (
to back out object.
DO NOT use aerosol products, petroleum based or aerosol lubricants on or
near shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON SHREDDER.
Vapors from propellants and petroleum based lubricants may combust causing
serious injury.
place near or over heat source or water.
BASIC SET UP
CASTER INSTALLATION
1
2
2 3
G.
KEY FEATURES AND CONTROLS
H.
I
A. Auto Feed Tray
B. Auto Feed Flap
C. Disconnect Power Switch
1. OFF
2. ON
D. Manual Feed Slot
E. Pull-Out Bin
F. Casters
G. Auto Feed Tray Extension
Maximum:
Sheets per pass (Auto Feed) ....................................................................................... 100*
Sheets per pass (Manual Feed) .................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .....................................................................................8.7 in. (220mm)
* 8.5 in. x 11 in., 20lb., (75g) paper at 120V/60 Hz, 3.5Amps; heavier paper, humidity
or other than rated voltage may reduce capacity. Recommended daily usage rates:
1,000 sheets; 15 credit cards.
position to operate shredder. In case of emergency, move switch to OFF ( )
position. This action will stop shredder immediately.
the voltage and amperage designated on the label. The grounded outlet or
) socket must be installed near the equipment and easily accessible. Energy
converters, transformers, or extension cords should not be used with this product.
4
ENGLISH
Model 100M
H. See Safety Instructions
I. Control Panel and LEDs
1. Reverse
2. ON/OFF and Start (blue)/Bin Open
3. Remove Paper (red)
4. Bin Full (red)
5. Overheat (red)