Bartscher BS1240L Instrucción De Servicio página 41

Setting the desired temperature (desired value)
•
to set or change the desired value, press and hold the button
than 2 seconds;
•
the desired value will be displayed, and „
on the digital display;
•
increase or reduce the value using the buttons
desired value appears on the digital display;
•
confirm the new value by pressing button
value will be saved automatically.
NOTE!
If no button is pressed in the next 10 seconds, the digital display will
show the temperature inside the mini cold room.
The display shows the value of temperature which is measured near the
temperature sensor and is used for controlling the compressor.
NOTE!
To change parameters or gain access to additional settings, use the enclosed
temperature control guide or contact the technical service.
Automatic defrost
The device's automatic defrost cycle runs 4 times every 24 hours.
Manual defrost
When the cooling capacity decreases, e.g. after opening the door for too long, it is
necessary to perform the manual defrosting. To start the defrosting, press the manual
defrost button and hold it for at least 3 seconds
The LED defrost indicator „
Tips for cooling food products
•
When the set temperature is reached inside the device, the LED cooling indicator
will go off and the unit is ready to hold relevant food products.
•
Prepare the food products in advance and place them in the appropriate GN
containers.
•
Warm food should be cooled to room temperature prior to placing it in the
mini cold room.
" will come on.
" or „ " LED will start flashing
or , until the
or wait 10 seconds, the set
for more
- 37 -