later the alarm will ring again and so on until the next alarm rings.
Note: The Snooze interval time is 9 minutes.
-
To turn the Snooze function off, press once on AL.1 / AL.2 button (6/7).
-
Press and hold the AL.1 / AL.2 button (6/7). The alarm icon will disappear to
indicate the alarm is disabled.
SLEEP OPERATION
When listening to radio, press Snooze / SLEEP button (3) to enter sleep mode.
You can just adjust the sleep timer from 90 mins to 10 mins by pressing the
Snooze / SLEEP button (3). The unit will automatically turn off after the selected
time
RADIO MODE
Note: Ensure that the FM antenna is completely unrolled and extended to have
the best FM reception.
Press the ON/OFF button (4) to turn the unit ON.
Use the Tune
(5) or Tune
station. If you press and hold the Tune
then release, the unit will automatically scan to the next broadcasting station.
Press the ON/OFF button (4) to turn the radio OFF.
TO SET / RECALL THE RADIO PRESETS
Press the ON/OFF button (4) to turn the unit ON.
Use the Tune
(5) or Tune
Press the SET - MEM/M+ button (2); "P02" will blink in the display.
Press the SET - MEM/M+ button (2) again to set the preset.
Repeat steps 2 through 4 to set more presets.
The unit can preset 10 stations totally for FM.
When "P01-P10" is blinking, press the Tune
select the preset number.
When recalling preset stations, press SET - MEM/M+ button (2) to select the
preset number.
RESET
If the system does not respond or exhibits erratic or intermittent operation, you
may have experienced an electrostatic discharge (ESD) or a power surge that
triggered the internal microcontroller to shut down automatically. If this occurs,
simply disconnect the AC power cord and remove the system backup battery,
wait at least 3 minutes and then setup the unit again by following the manual.
RADIO OPERATION
(1) button to select the desired FM radio
or Tune
(1) button to select the desired FM station.
(5) or Tune
15
button for 3 seconds,
(1) button to