Aquarea PAW-TG20C1E3STD Instrucciones De Uso página 27

Dear buyer, thank you for purchasing our product.
PRIOR TO THE INSTALLATION AND FIRST USE OF THE HOT WATER STORAGE
TANK, PLEASE READ THESE INSTRUCTIONS CAREFULLY.
This storage tank has been manufactured in compliance with the relevant Standards and tested by the relevant authorities as
indicated by the Safety Certificate and the Electromagnetic Compatibility Certificate. The technical characteristics of the product
are listed on the label attached to the protective cover.
The connection of the storage tank to the plumbing and power networks must be carried out by qualified staff only. All repairs
and maintenance work in the interior of the storage tank, as well as limestone removal or testing or replacement of the corrosion
protection anode, may only be carried out by an approved maintenance service provider.
The hot water storage tank is designed in a manner which allows using the following heating sources, via a heat exchanger:
• Central heating hot-water system,
• Solar power,
• Heating pump.
INSTALLATION
The heater should be installed in a dry room that is not subject to freezing conditions, preferably in the vicinity of other sources
of heating (e.g. boiler room). Prior to installation screw on the enclosed adjustable legs. Level the storage tank longitudinally and
transversally by rotating the adjustable legs.
Image 1: Connection and installation dimensions of the storage tank [mm]
PAW-TG20C1E3STD
A 1535
B 180
C 300
D 880
G 780
H 1355
I 335
J
580
1
G 3/4
2 G1
3 G 3/4
4 G1
5 G 3/4
øJ
5
4
3
2
1
PAW-TG20C1E3HI PAW-TG30C1E3STD
1675
220
340
1015
945
1435
375
680
G 3/4
G1
G 3/4
G1
G 3/4
KEY
1 Cold water inflow
2 Medium outlet from the heat exchanger
3 Circulation conduit
4 Medium inflow into the heat exchanger
5 Hot water outflow
1590
175
270
890
740
1410
320
680
G1
G1
G 3/4
G1
G1
27