Parking Brakes - RED CASTLE whizz Instrucciones De Uso

Instructions for use
1. UNFOLDING
-
Open the locking hook on the side of the
chassis and raise the handlebar (1 and 2).
-
When using for the first time, attach the seat
straps around the chassis. Don't make them
too tight. (3).
WARNING
: Make sure that the handlebar
and the chassis are secured firmly in place
(click heard).
2. WHEELS
FRONT WHEEL
-
The stroller comes with the front wheel fitted.
-
To remove it, unscrew the plastic caps from
GB
the front wheel axle, then unscrew the screws
from both sides of the axle (4).
REAR WHEELS
-
Both wheels will block into place automatically.
(click heard) (5).
-
To remove them, pull on the grey lever,
removing the wheel at the same time (6).

3. PARKING BRAKES

-
Pushing down on the horizontal bar with your
foot will lock the rear-wheels (7).
WARNING
: It may be dangerous to leave
your child alone and unattended in the
stroller, even if the parking brake is on. Check
that the wheels are securely locked.
-
To unlock, lift up the horizontal bar with your
foot (8).
4. ADJUSTMENTS
FRONT WHEEL SWIVEL OR FIXED
SWIVEL POSITION:
-
Lift up the foot rest (see FOOT REST paragraph)
-
Lift up the lever lock located below the foot
rest to lock it in place (9).
FIXED POSITION:
-
Lower the lever lock as shown (10).
35
WARNING
: This product is not suitable for
running or skating.
WARNING
: The swivel wheel allows greater
manoeuvrability of the stroller. Over rough
grounds (sand, snow, stones, mud...), it is
strongly recommended that the front wheel
be used in the fixed position.
THE SEAT BACK
-
The seat back has 3 positions: sitting, reclining
and lying down. To change positions just open
the 2 (or 4) zips on either side of the seat back.
PLEASE NOTE! The zips must be fully opened in
order to avoid breaking them.
-
Sitting position = zips closed (11)
-
Reclining position = 2 zips open (12)
-
Lying down position = 4 zips open (13)
-
Use the Velcro bands inside the seat, one on
either side, to attach or detach the pleats in
the fabric (14).
HOOD and INNER NETTING HOOD
The hood fits on easily:
-
Position the brackets as shown (15). Check
that they are correctly in place, clip them on
(to the hole on either side of the chassis) then
secure them in place (16).
-
To remove them, inverse the procedure.
-
When the seat back is in the lying down
position, close with the velcro strips located at
the back of the hood and/or the inner netting
hood (17).
-
For better air circulation during warmer
weather, the rear of the hood unzips and
detaches revealing an inner netting hood for
finer weather (18).
-
Hood down: levers on hood pushed flat (18a).
-
Hood up: levers on hood raised (18b).
HANDLEBAR
It is height adjustable.
-
Press on the large buttons located either side
of the handlebar and keep them pressed to
the required height then release them (click
heard) (19).