Functionality; Initial Use; Mounting The Light; Installing The Light - LIVARNO LUX 295693 Instrucciones De Montaje, De Uso Y De Seguridad

Expired or drained rechargeable batteries may
leak chemicals which will damage the product.
Remove, therefore, the rechargeable battery
when the lamp is not required for any length of
time.
WEAR PROTECTIVE GLOVES!
Leaked or damaged rechargeable
batteries could cause chemical
burns on contact with the skin; you should
therefore wear suitable protective gloves at all
times if such an event occurs.
Only use rechargeable batteries of the correct
size and and the recommended type (see sec-
tion "Technical data").
Ensure correct polarity, indicated in the battery
compartment.

Functionality

The solar cell built into the product converts sunlight
into electricity and stores it in a Ni-MH rechargea-
ble battery. The light switches on at dusk. The built-
in LED is an energy-saving light bulb with a very
long life. The light duration depends on the amount
of sunlight, the angle at which light hits the solar
panel, and the temperature (the battery capacity
varies by temperature). A vertical angle of light at
temperatures above the freezing point is ideal. The
rechargeable battery will only achieve its maximum
capacity after several charging and discharging
cycles.

Initial use

Mounting the light

WEAR PROTECTIVE GLOVES!
Wear protective gloves when as-
sembling and setting up the light!
10392A/B:
Pull the solar cell housing
lampshade out of the lamp body
1
Push the ground stake
and into the lamp body
16 GB/IE
including
2
.
3
out of the adapter
4 5
.
3
Push the ground stake
the desired location and attach the lamp
body .
3
Set the ON/OFF switch
marked „ON" to allow the product to switch
on in the dark.
Reattach the solar cell housing
shade to the lamp body
1
light is now ready to use.
10392C/D:
Pull the solar cell housing
shade out of the lamp body
1
Push the ground stake
and into the lamp body
Push the ground stake
the desired location and attach the lamp
body .
3
Turn the solar cell housing
shade counter-clockwise.
1
Set the ON/OFF switch
marked „ON" to allow the product to switch
on in the dark.
Insert the solar cell housing
shade and tighten clockwise. Your solar
1
light is now ready to use.

Installing the light

Push the ground stake
ground (lawn, flower bed) so it is firmly posi-
tioned upright in the ground. Then attach the
assembled solar light to the ground spike
Make sure it is firmly positioned. Do not use
force when assembling or setting up the prod-
uct, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set
the solar garden lamp up in a place where the
solar cell will get direct sunlight for as long as
possible.
Make sure the solar cell is not impacted by
other light sources, e.g. yard or street lighting,
or the light will not switch on at dusk.
The light will automatically switch on in low
light and switch off in normal daylight.
into the ground in
4
to the position
7
with lamp
2
. Your solar
3
including lamp-
2
.
3
out of the adapter
4 5
.
3
into the ground in
4
out of the lamp-
2
to the position
7
into the lamp-
2
far enough into the
4
.
4