Replacing The Rechargeable Battery; Charging; Maintenance And Cleaning; Troubleshooting - LIVARNO LUX 295693 Instrucciones De Montaje, De Uso Y De Seguridad

Replacing the
rechargeable battery
The batteries should be replaced every 12 months
to ensure optimum performance.
10392A/B:
Remove the lampshade
body .
3
Pull the solar cell housing
lampshade .
1
Switch off the light using the ON/OFF switch
by setting the switch to the „OFF" position.
Remove the fastening screws
cross-tip screwdriver. Then open the battery
cover on the solar cell housing
flat-head screwdriver.
Replace the old battery
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
batteries of the recommended type (see
„Technical data").
Close the battery cover and tighten the retain-
ing screws using a small cross-tip screw-
8
driver. Set the ON/OFF switch
„ON" position.
Reattach the solar cell housing
shade . Then assemble the remaining parts
1
of the lamp.
10392C/D:
Remove the lampshade
body .
3
Turn the solar cell housing
lampshade counter-clockwise.
1
Switch off the light using the ON/OFF switch
by setting the switch to the „OFF" position.
Remove the fixing screws
cross-tip screwdriver.
Replace the old battery
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
from the lamp
1
out of the
2
using a small
8
using a
2
with a new re-
10
. Use only rechargeable
9
to the
7
to the lamp
2
from the lamp
1
out of the
2
using a small
8
with a new re-
10
. Use only rechargeable
9
batteries of the recommended type (see
„Technical data").
Tighten the retaining screws
cross-tip screwdriver. Set the ON/OFF
switch to the „ON" position.
7
Reattach the solar cell housing
shade . Then assemble the remaining parts
1
of the lamp.

Charging

7
Please note, the solar garden light must be
switched on when the battery is charging. The
charging time via the solar cell varies by the inten-
sity of the sunlight and the incidence angle of light
onto the solar cell. Place the solar cell as perpen-
dicular as possible to incidence angle of light. This
will ensure the brightest light.

Maintenance and Cleaning

The LEDs cannot be replaced. The solar lamp is
maintenance-free, except for any necessary
change of battery.
Routinely clean the solar light with a dry, lint-
free cloth. Use a slightly moist cloth if very dirty.

Troubleshooting

Note: The device contains sensitive electronic
components. Radio transmitting equipment in the
immediate vicinity may therefore cause interfer-
ence. If you notice the device is malfunctioning,
remove any sources of interference from the area
7
around the device.
Note: Electrostatic discharge can cause malfunc-
tions. In the event of such malfunctions, briefly
remove and reinsert the rechargeable batteries.
with a small
8
to the lamp
2
GB/IE 17