NOTE
►
The appliance is will not work if the heating element
In that case, "
Handling and use
Switching the appliance on/off
Press the button
water temperature
Press the button
The display
Adding the food
Place the vacuum bag with the prepared and vacuum-packed food in
the pot. Note that the water level must not exceed the MAX marking. If
required, ladle out the water with a cup.
NOTE
►
The vacuum bags should always be covered with water during operation.
If the vacuum bags float to the surface, weigh them down with a suitable
weight (e.g. a plate).
Programming the appliance
To set the water temperature for the desired cooking process by degrees,
press the buttons + / –
is blinking. The selected temperature will appear on the display
set values between
of the buttons + / –
Press the button
do so, repeatedly press the buttons + / –
number of hours will change rapidly in steps of 1 h.
Press the button
desired cooking time. To do so, repeatedly press the buttons + / –
You can set values between and
the buttons +/–
1 min.
Press the button
ing up and circulate the water in the pot. The temperature indicator
the display
SSVS 1000 A1
" will light up on the display
to switch on the appliance. On the display
will flash and the time indicator
for 2 seconds if you want to switch off the appliance.
will then go out.
, °C and
/ , the temperature will change rapidly.
/
and you can enter the number of hours for the desired cooking time. To
and
. If you press and hold down one of the buttons +/–
/
/ , the number of minutes will change rapidly in steps of
to start the program. The appliance will begin heat-
shows the current water temperature.
/
repeatedly while the temperature indicator
, °C. If you press and hold down one
. Now, the time indicator
/ . You can set values between
. Now, you can enter the number of minutes for the
. If you press and hold down one of
is not in the water.
.
, the set
will be lit.
. You can
is blinking on the display
/ , the
/ .
27
GB│IE
│
on
■