AudioSonic CL-500 Manual De Instrucciones página 10

CONNECTIONS
Antenna Connection
The clock radio comes with an FM wire antenna at the rear, please extend for best
reception.
Mains Power Supply
Before plugging the power cord into the AC outlet, check to make sure all of the
assembly instructions have been followed. Now carefully plug the power cord into the
wall outlet.
Press al. off button on top of the unit to turn it on.
Power Source
The unit is powered by 230V~50Hz mains power supply. The CR2032 button cell (not
supplied) is used for clock back-up only. Please remove the battery during long periods
of non-use to avoid battery leakage.
To avoid damages not covered by the warranty only connect the unit to above power
supply.
Insert/Change Back-Up Battery
Insert the back-up battery in the battery compartment at the bottom of the unit; you
need a Phillips screwdriver to open the battery compartment. Please observe the
polarity.
Change the back-up battery once a year.
Your settings (alarm, station memory, etc.) are retained during power failure or when
disconnecting from mains power supply to replace the light bulb; the unit automatically
switches to back-up battery.
NOTE: Please dispose of exhausted batteries environmentally responsible.
line in Jack
Connect your portable MP3 player or other audio devices via 3.5mm jack audio cable
(not supplied) to play back via your clock radio.
GB-9