AudioSonic CL-500 Manual De Instrucciones página 9

Fig. B
Fig. C Light bulb
Locating ring
Lamp shade
Light bulb holder
Lamp stand
2. Remove the lamp shade as shown in Figure B.
3. Turn the lamp shade around and place it on
top of the light bulb holder as shown in Figure
C. Replace the locating ring by turning it
clockwise.
4. Before installing or exchanging a light bulb
press on/off to turn the light off. Disconnect
from mains power supply. Do not pull the cord;
always take hold of the plug.
5. Gently turn the light bulb counter-clockwise and
remove it from the light bulb holder.
WARNING: Do not attempt to replace the light
bulb immediately after it has burnt out. Please
let it cool down. Turn off the light and ensure
that the unit is disconnected from mains power
supply.
6. Insert only E27 type A max. 60W standard/
frosted regular light bulbs (as supplied).
WARNING: Please hold the light bulb carefully
to reduce the risk of breaking.
7. Connect the unit again to mains power supply.
8. Press on/off to turn the light on.
GB-8