X-Rite i1 PRO Manual De Usuario página 31

To prepare your i1Pro device for projector measurements you need to mount the tripod
holder on the tripod holder base plate, or on a tripod with a standard 1/4" screw you
your device is calibrated and the status indicators are pulsating white before you mount
the device.
1. To mount the tripod holder on the tripod holder base plate, insert the 1/4" screw of
the tripod holder base plate into the screw nut on the bottom of the tripod holder.
Turn the tripod holder base plate clockwise until the tripod holder is fastened to the
tripod holder base plate. If you are mounting the tripod holder on a tripod, follow the
instructions for mounting a tripod head in the user manual of your tripod.
2. Mount the i1Pro measurement device on the tripod holder by inserting the mounting
connector on the tripod holder in the mounting interface at the rear of the i1Pro
device.
3. To remove the i1Pro device from the tripod holder, gently pull the mounting
connector with the tripod holder out of the mounting interface at the rear of the
i1Pro device.
i1Pro device on the tripod holder. Make sure that
EN
31