Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
20-E
-To start using the device you must place the switch On/Off in
position I. The button
on the control panel is used only as
'Stand by ' of the device, not for disconnection
INSTRUCTIONS FOR USE
PREPARATION AND CONDITIONING OF THE APPLIANCE
-Make sure that the on/off switch is in O position before plugging
it from the mains.
- To fill the water deposit, lift the cap on the top of the device and
fill with water through any of the departments, till the water level
indicator overcomes ("MIN") (fig.2).
IMPORTANT: never overcome maximum water level, ("MAX").
Capacity:9L.
-To empty the water deposit, open the cap on the bottom of the
device (between the two back wheels). See cleaning section.
WARNING: the deposit could have up to 9 litres of water, even if
the level indicator shows minimum ("MIN") .
TO START THE DEVICE
Connect the device to power supply.
Press the lateral button «k» (On/Off) to switch it on and put it in
position I.
Select the position of cold or warm air with the lateral temperatu-
re selector «L».
Now the device is ready to work, to activate the device press the
button I/0 on the control panel and the device will start operating.
Select the output speed of air you want, the button
can select three positions:
«I» - low air flow.
«II» - medium air flow.
«III» - maximum air flow.
Press the button
to select the desired position.
Button
(1). It is used to set the operation time of the device.
When the time is out the device will be automatically disconnec-
ted. To program it, simply press the button
press this button increases the set time a half hour to a total of
(5). You
. Each time you
seven hours. The lights indicate the scheduled time.
Wind blow mode
(4): To select the Wind blow mode of the
device you have to press the key
varies in intensity and direction gradually. If you want the tabs
stay in a certain position, when they are in the desired position,
press the button Wind blow
fixed.
Cold mode: button
(3). To get cooler and humid air place ice
in the largest compartment located at the top of the device (e) or
into the lateral water containers (f) and press
on it also purifies the air, if the light is off, only cool dry air is
coming out.
Heat Mode: place the temperature selector to the heat position
and press the button
(2). The hot air will come out.
Function Mode
(6): to select the type of wind blow you have
MODE
to press the button
. There are three types of wind blowing:
MODE
sleep mode, natural and normal. Select the desired one.
Remote control: controls the same functions of the device on the
distance of 5 meters.
Unplug the device when you finished using it.
CLEANING AND STORAGE
-Before cleaning the fridge, make sure the device is not plugged
in the current and the water/ice tank is empty.
- To empty the water tank in case of excess of the water or to
clean the device, open the drain plug in the lower back part, to
remove it turn the plug counter clockwise until it is separated from
the device, pull the rubber stopper and drain the water.
Once all the water is out, place the rubber stopper and drain plug
again.
-Please clean the water tank from time to time.
-The filter should be cleaned with a damp cloth approximately
every 15 days.
Steps to be taken to change the filter
1.- Take the grid out of the filter with the help of a screwdriver.
2.- Take the filter out of its deposit and shake well to clean.
3.- If the filter is too dirty, put it in a bowl with water and neutral
soap.
E-21
. With this function the air
again and the position will be
. With the light
Publicidad
Tabla de contenido
