Cleaning And Storage - JOCCA 5887 Manual De Instrucciones

20-E
INSTRUCTIONS FOR USE
PREPARATION AND CONDITIONING OF THE APPLIANCE
-Make sure that the on/off switch is in O position before plugging
it from the mains.
-Before plugging in the device you must fill the water deposit. To
do this, lift the cap on the top of the device and fill with water
through any of the departments (fig.1) , till the water level indica-
tor overcomes "LOW" (fig.2).
IMPORTANT: never overcome maximum water level, "MAX".
Capacity:9L.
-To empty the water deposit, open the cap on the bottom of the
device (between the two back wheels).
WARNING: the deposit could have up to 6 litres of water, even if
the level indicator shows minimum.
START UP OF THE APPLIANCE
1.- Plug in the device.
2.- Select either cold or warm air position a.
3.- Press r (I/O) button to start the device.
4.- Select air exit speed you wish by pressing "
There are three positions:
"I"- low quantity of air.
"II"- minimum quantity of air.
"III"- maximum air speed.
Take into account that the maximum wealth III only can work for
cool, for the function warm, only are available the positions I and
II.
-Press the button as many times as you need, till you get the air
quantity you are looking for.
5.- " " button (b) allows you to programme the time you want
the device to work. Once that time is over, the device will switch
off automatically.
-To do this, you need only to press "
do it you increase half an hour more to the selected time, up to a
maximum of seven and an half hours.
-Lights indicate selected time.
6.- Progressive mode (c): To select this mode on your device you
" button(d).
" button. Every time you
have to press " " key. With this function air will progressively
change its speed.
7.-" " cool position (f). To obtain a more fresh air put ice cubes
inside the biggest compartment on the top (q) of the device and
press key.
8.- Warm position: put the cltod air/hot air button on the "
(a) position. Press " " key (e) to select either I (1.000W) or II
(2.000W).
9.- Remote control: The range of the remote control is five
metres.
WARNING: Before changing position from cold air to hot air, or
the other way around, first switch off the device, wait for a few
seconds and switch it on again.
10.- Unplug the appliance from the mains when you have finis-
hed using it.
WARNING: If the device is in position heat, and you want to
turnn off it, press the button I/O and wait 30 seconds until this one
turn off automatically.

CLEANING AND STORAGE

-Before cleaning the fridge, make sure the device is not plugged
in the current and clean it first.
-Please clean the water tank from time to time.
-The filter should be cleaned with a damp cloth approximately
every 15 days.
-Steps to be taken to change the filter
1.– Take the grid out of the filter with the help of a screwdriver.
2.– Take the filter out of its deposit and shake well to clean.
3.– If the filter is too dirty, put it in a bowl with water and neutral
soap.
4.– Put the clean filter, carefully, inside the deposit.
NOTE: Filters usually last 1 year, in case any accident with it,
change it immediately.
Disconnect the appliance from the mains supply if it is not going
to be used for some time.
E-21
"