Ondal Acrobat 2000 WA04/75 Instrucciones De Montaje página 16

2 Mounting the extension arm and spring arm
2 Mounting the extension arm and spring
arm
Please be sure to observe the safety information in section 1.
2.1 Preparing for mounting
Figure 1
1. Undo setscrew M3
cap for covering the spigot
2. Check that the rotor disk
spigot is greased (recommended lubricant: Optimol; Optipit grease).
2.2 Mounting the wall arm
Figure 2
1. Carefully place the wall arm
mounting element
connections in the spigot
2. Check the swivel range of the wall arm
and remove protective cap
(e.g. for when servicing) at a future date.
Ø 48mm is fitted on the spigot
/ vertically over the spigot
- . The electrical connection is made via plug
and wall arm
16
Keep the protective
, and that the
of the
/ .
/ and that it is securely in place.
GB
B
D