Switching The Appliance On And Off; Starting And Stopping The Cooking Cycle - Blanco BC PC 4200 Manual De Uso

SWITCHING THE APPLIANCE ON AND OFF

Switching on
1 - Turn off the appliance's circuit breaker to
disconnect it from the electrical mains.
Icon (e5) illuminates.
2 - Press button (A) to set the circuit board in
standby mode.
Icon (e5) goes out and icons (e4) illuminate; 4 red
dashes will appear on the display (e6).
3 - Press button (A) again to
appliance and start the cooking cycle.
The temperature will appear in red on the display (e6).

STARTING AND STOPPING THE COOKING CYCLE

Starting
To carry out this operation, proceed as fol-
lows.
1 - Switch on the appliance (see page 8).
2 - Press button (D) once, twice or three times
to select the three heating element operat-
ing modes.
- left icon on: the front heating element is on (see also
electrical system diagram fig.1 at the back of the
manual).
IT
- left and middle icons on: the middle and rear
heating elements are on (see also electrical system
diagram fig.2 at the back of the manual).
GB
- All three icons on: the front, middle and rear
heating elements are on (see also electrical system
DE
diagram fig.3 at the back of the manual).
3 - Press buttons (B) and (C) to decrease or
FR increase the temperature set.
The temperature appears in red on the display (e6);
ES
once the set temperature is reached, it will be
shown in green.
Stopping
1 - Press button (A) to switch the appliance to
standby mode and stop the cooking cycle.
2 - Press button (A) again to switch the appliance
OFF.
3 - Turn off the appliance's circuit breaker to
disconnect it from the electrical mains.
English
Switching off
1 - Hold button (A) down for ±6 seconds to switch
The appliance is still powered up.
2 - Turn off the appliance's circuit breaker to
switch on the
- 8 -
the appliance off.
Icon (e5) illuminates.
Important
disconnect it from the electrical mains.