Dornbracht Touchfree Instrucciones De Uso página 12

Product configurations
The factory settings give optimum support to the automatic
teach-in to ensure that the product is ready for use as quickly
as possible.
The settings can be adjusted to suit local conditions and
individual needs.
2
1 3
CLEANING STOP
Triggering sensitivity
The sensitivity of the sensor's response to initial movements, that
is when the valve opens for the first time, can be adjusted
gradually. The factory setting is 50 % of the maximum sensitivity.
4
min. max.
The sensor's response ranges from insensitive to very sensitive,
depending on the setting (twist controller 4).
Run-on time
The run-on time defines how long the water continues to run
once the sensor no longer detects any movement. The factory
setting is 2 seconds.
2s 4s
2
1s 6s
The valve closes 1, 2, 4 or 6 seconds after the last movement,
depending on the setting (twist controller 2).
12
12h 24h
1
Auto
off
2s 4s
4
2
1s
3 sec
+ -
3
++ --
4
min. max.
Scan QR Code to
visit Touchfree Guide
English
Hold sensitivity
To prevent the continued flow of water (after the initial activation
and the set run-on time), the sensitivity of the sensor can be
adjusted so that it does not detect any further movements. The
factory setting is "++" (very sensitive).
3
++ --
48h
The sensor's response to movements is very sensitive ("++"),
sensitive ("+"), less sensitive ("-") or insensitive ("--"), depending
6s
on the setting (twist controller 3).
Automatic rinsing
Automatic rinsing can be activated to prevent germ formation
from stagnant water in the drinking water pipe. Automatic rinsing
is deactivated in the factory setting.
1
Auto
Automatic rinsing is either deactivated ("OFF"), or the valve opens
12, 24 or 48 hours after the last use, depending on the setting
(twist controller 1). Rinsing takes 15 seconds.
+ -
12h 24h
off 48h