⑵Status Adjustment Of The Tiller - LONCIN 1WG3.5-75FQ-D Manual De Uso

3. Check air filter
Warning!
Never try to run the engine without the air filter, if so, the engine will be worn more
quickly.
⑵ ⑵ ⑵ ⑵ Status adjustment of the tiller
1. Adjustment of handle frame
Note: Before adjusting height of handle frame,
please put the machine on a flat horizontal
ground to prevent it from accidental falling.
● Loosen the lifting handle and select the hole in
an appropriate position, then adjust the handle's
cross bar to as high as user's waist, then turn the
lifting handle to tighten it (See Fig.5).
2. Adjustment of tilling depth
3. Adjustment and use of clutch
Note: Before using the clutch, lower the engine speed.
● By "engage " and "disengage "of the clutch, the user can control output of engine's power.
● When the user holds tight the clutch lever, the clutch is engaged and transmits engine power to
the tiller and tilling blades begin to rotate. (See Fig.7)
● By adjusting height of damping lever, tilling depth can be
adjusted. Specifically, adjusting the lever downward will
increase tilling depth, and adjusting it upward will decrease
tilling depth. (See Fig.6)
6