Publicidad
Idiomas disponibles
Idiomas disponibles
Door Swing Reversal
Reversing the door swing
The refrigerator has the capability of
opening the door from either the left or the
right side.
The unit is delivered to you with the door
opening from the left side.
To change the opening direction, please
follow these instructions.
Note: Before reversing the door swing,
unplug the appliance from the mains or
disconnect the electrical power supply.
1. Remove the screws (1) holding the top
panel (2) to the unit.
Remove the top panel
2. Remove the two screws (3) holding the top hinge (4) (right side) to
the frame. Remove the top hinge (4).
3. Lift the door off the middle hinge pin and place it on a non-
scratching surface.
4. Remove the two screws (5) holding the middle hinge (6).
Remove the middle hinge (6).
5. Lift the lower door off the bottom hinge pin and place it on a non-
scratching surface.
6. Remove the two screws (7) holding the bottom hinge (8).
Remove the bottom hinge (8).
7. Remove the left front leg (9) and transfer it to the right side.
8. Before replacing the bottom hinge (8), remove the hinge pin (10)
and reverse the direction of the hinge (8). Reassemble the bottom
hinge (6) on the left hand side using the two screws (7).
9. Refit the hinge pin (10) into the bottom hinge (8).
10. Lower the door onto the bottom hinge pin (10).
11. While holding the lower door in the closed position, reassemble the
middle hinge (6) on the left hand side using the two screws (5). Do not
tighten the screws (5) until the top of the lower door is level with the
counter top.
13.
Before replacing the upper hinge (4), remove the hinge pin (11)
and reverse the direction of the hinge (4).Refit the hinge pin (11) into
the upper hinge (4). Lower the upper door onto the middle hinge pin.
14. While holding the upper door in the closed position, reassemble the
upper hinge (4) on the left hand side using the two screws (3). Do not
tighten the screws (3) until the top of the upper door is level with the
counter top.
Door opening from left side
15. Refit the top panel (2) using the screws (1).
26
Publicidad
