Troubleshooting - Telstar TMU060310MD Manual Del Instrucciones

TROUBLESHOOTING

When followings occur, it is not the cooker fault, please carefully check once before
sending it for repair.
PROBLEM
Difficult to close
the lid
Difficult to close
the lid
Steam leaks from
the lid
Steam leaks from
float valve
Float valve unable
to rise
Steam comes out
from exhaust valve
non-stop
Power indicator
doesn't light on
REASON
-Sealing ring not installed
properly.
-The floater valve clamps the
push rod.
-Float valve in the popped-up
position.
-Pressure exists inside the cooker.
-Sealing ring installed
improperly.
-Food debris attached to the
sealing ring.
-Sealing ring damaged.
-The lid is not closed correctly.
-Food debris on the float valve
gasket.
-Float valve gasket worn-out.
-Too little food and water in
inner pot.
-Steam leaks from the lid or
exhaust valve.
-Exhaust valve not in sealing
position.
-Pressure control fails.
-Power socket bad contact.
Olla Multiuso
TMU060310MD
SOLUTION
-Position the sealing ring well
-Lightly push the push rod
-Press the float
valve lightly with a chopstick.
-Open the lid after the pressure
is completely released.
-Install the sealing ring as
required.
-Clean the sealing ring.
-Replace the sealing ring.
-Close the lid correctly.
-Clean the float valve gasket.
-Replace the float valve gasket.
-Add water and food according
to the recipe.
-Send to the service center for
repair.
-Turn the exhaust valve to the
sealing position.
-Send to the service center for
repair.
-Please check the power socket.