The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
14. Have your product repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorized service centre is recommended.
15. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
3.3- Specific instructions for use
1. The use of this product by children is forbidden.
2. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damage
4.2- Assembly
4.2.1- PP75/xxx
l) The installation mast (or supporting
steel pipe, not included) should be
vertically positioned.
It should have an outside diameter of
48mm and a wall thickness of 6mm.
The surface of supporting steel pipe
should be rough, not smooth and paint, in
order to increase the friction.
Ensure that proper verticality and rigidity,
of the 48mm supporting steel pipe, is
maintained in any case.
2) The installation distance between
brackets should be controlled at 480mm.
3) For proper installation on the mast,
Fig.2
follow instructions as shown in Fig.2.