Maintenance And Storage - Ribimex Ribitech PP120 Manual De Instrucciones Y Mantenimiento

4.2.2- PP120
1) Follow the above instructions 4.2.1.
2) For proper installation of the protrusion
bar, follow instructions as shown Fig.3.
3) When mounting the hoist, make sure to
use the rubber blocks to avoid slippage of
the bracket on the protrusion bar..
V. OPERATION
5.1- Intended use
The hoist frame is applicable to mini electric hoists (within the limits of the lifting capacity).
The hoist frame is intended to mount one hoist only.
5.2- Operation
1) Choose the adequate electric hoist
2) Make sure the cantilever is tight during installation and
does not have any slippage.
3) After installation, proceed with following verifications
at least 2 times:
a) up and down no-load testing
b) 45° left and right rotation testing
c) Then add the load to rated capacity and slowly lift it.
4) After testing is complete, please tighten the bolts
5.3- Advise for users
- Periodically check the supporting steel pipe to make
sure that it doesn't rock nor bend
- Regularly check all the structural parts of the hoist frame
to make sure there is no damage and cracking.
- Do not overload.
- Do not lift persons.
- Do not stand under the hoist.
- Persons who do not know the safety knowledge of the product, the installation and operating
procedures must not operate the product
- It is strictly forbidden to use two electric hoists to sling or support a weight simultaneously.
VI. MAINTENANCE AND STORAGE
6.1- Maintenance
After use, regularly check every part of the hoist frame to make sure that there is no damaging, or
loosened bolt and nuts, especially the clamping bolts.
Product must be properly packaged after disassembling for transportation, and do not omit any part.
6.2- Cleaning
- Clean product with a soft clean cloth.
- Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Fig.3
Fig.4