Technical Data; Intended Use; Safety Instructions - Festool VB-CMS/CS50 Instrucciones De Montaje

GB
VB-CMS/CS 50
1

Technical data

VB-CMS/CS 50
Bench dimensions, outer
(width x length)
Bench height
with foldaway legs
without foldaway legs
Weight
2 Symbols
Manual, read the instructions
The specified illustrations appear at the be-
ginning of the Operating Instructions.
3

Intended use

When the widener VB-CMS/CS 50 is fitted
(on the right or left side of the bench), the
saw table of the CS 50 EB or the basic unit
CMS-GE is widened by 481 mm.
The user bears the responsibility for damage
and accidents caused by improper use.
4

Safety instructions

Warning! Read all safety warnings
and all instructions. Failure to follow the
warnings and instructions may result in elec-
tric shock, fire and/or serious injury.
Save all warnings and instructions for
future reference.
– Position the bench on a stable, level, hori-
zontal surface. If the bench slides or wob-
bles, it may not be possible to control the
power tool safely and reliably.
– Do not overload the bench and never use it
as a ladder or trestle. Overloading or
standing on the bench will make it top-
heavy and it will most likely tip over.
5 Assembly
Ensure that the floor around the machine
is level, in good condition and free of
loose objects (e.g. chips and offcuts).
To fold out the legs
tary knobs [1-1]
rotary knobs again once the legs are un-
folded.
6
773 m x 481 mm
900 mm
180 mm
11,3 kg
[1-2] open the two ro-
to the stop. Tighten the
If necessary, loosen the screws [3-2].
Place the widener VB-CMS/CS 50 from
above on the groove of the CMS-GE/
CS 50 EB (Fig. [2]). Ensure that the pro-
file groove on the CMS-GE/CS 50 EB and
VB-CMS/CS 50 [3-4]
Adjust the height of the VB-CMS/CS 50 on
both sides using the screws
CMS-GE/CS 50 EB.
Lock the VB-CMS/CS50 on both sides with
the screw [3-2] on the CMS-GE/CS 50 EB.
To ensure that the machine is stable and
level, the length of both legs can be al-
tered by turning the end caps [3-3].
Before using the equipment, ensure that
the profile plate is firmly secured in the
bench opening with the screw [3-5].
Disassembly
Disassembly is performed in reverse se-
quence to assembly.
Alignment of the profile groove
Check after installation whether the pre-set
profile setting rail can be pushed without any
problems between saw table and table wid-
ener. If not:
Position the pre-set profile setting rail so
that it makes equal contact with the saw
table and the table widener.
Open the screws [3-2].
Secure the angle stop in the specified po-
sition.
Tighten the screws [3-2].
REACh for Festool products, its acces-
sories and consumable materials:
REACh is a European Chemical Directive that
came into effect in 2007. As "downstream
users" and product manufacturers, we are
aware of our duty to provide our customers
with information. We have set up the follow-
ing website to keep you updated with all the
latest news and provide you with information
on all the materials used in our existing prod-
ucts:
www.festool.com/reach
are in alignment.
[3-1] to the