Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USER GUIDE
be cleared. The phonebook will not be changed.
Press SET/OK key, then using the direction keys to select HS DEFAULT item.
Press SET/OK key to confirm.
The user will be prompted to enter the PIN code, key in the PIN code (default 0000)
Press SET/OK key to confirm. If the PIN code is validated all handset settings will be
returned to the factory default.
Handset Menu function 5: REGISTRATION
This function allows the user to register the handset to a specified base.
Before registering a handset to the base, the base should first be put into subscription mode
Press SET/OK key, then using the direction keys to select REGISTRATION item.
Press SET/OK key to enter.
Press the direction keys to select BASE name. (If the handset already has a registration
to a base , there is a "+" on the right side of the display)
Press SET/OK key to confirm. The display shows PIN?, key in the 4 digit PIN code for the
base. (the default PIN code is 0000)
Press SET/OK key to confirm, and the display will flash "SEARCHING 1"(or 2,3,4)
At the same time, on the base, press MENU key, then press ▲/CID or ▼/OUT key
to choose REGISTRATION, press MENU to confirm, "SEARCHING" will flash on base
display.
After a short delay, if the registration is successful, there will be a confirmation beep, and the
handset display will go back to idle mode with the handset number shown (e.g. HS1,HS2). The
base display will also go back to idle mode.
OPERATION
Speakerphone operation & volume control
Press HANDSFREE (
on base or handset) key once to obtain a dial tone, dial your number,
when you hear the called party answers the phone. You can begin your conversation without
picking up the handset, you can also answer an incoming call by pressing HANDSFREE (base
or handset) key.
If you answer the call by pressing HANDSFREE key or pick up the handset of the base, to hear
other party clearly, please pick up the handset to approach your ear for conversation.
During the speakerphone operation, the user can adjust the speaker volume level by pressing
the the direction keys key (VOL+ or VOL- key), total 6 levels for selection.
NOTE: If you use earpiece, you can press the the direction keys key (VOL+ or VOL- key) to
adjust the earpiece volume, total 5 levels for selection.
Mute the mouthpiece
During a call, press MUTE key once to mute the mouthpiece and "MUTE" will show on LCD.
Press MUTE key again to get back to the call and the "MUTE" will disappear.
Caller ID – type I & II
TYPE I
After you have applied the caller ID service, you can see the caller party phone number during
an incoming ring.
TYPE II
ITCOMBO100
43
EN
Publicidad
Tabla de contenido
