Factory Setting - VDS INV Istrucciones De Uso

Note:

FACTORY SETTING

Opening speed frequency in Hz
Closing speed frequency in Hz
Opening in slow speed frequency in Hz
Closing in slow speed frequency in Hz
Function 02 - Select type of automation motor single-phase 230Vac
.
= PS (Sliding Door / Sectional / Gate).
.
= PF (Fridge door).
.
= PL (Folding door).
PROCEDURE:
Press P3 until
Press P2 (Forward)
Press again P3 and release.
On Display appears
(NOTE: The sub-menu selection is distinguished from the point after the digit).
If you need to select another type of automation press the P2 button to display the
number corresponding to the type of automation desired.
Confirm with P3.
After programming follow the procedure for ESC:
Press P2 (Forward) or P1 (Backward) until you see
Confirm pressing P3.
Learning of opening and closing work times
Automation in the closed position and check the position of the DIP 4
PROCEDURE:
Ÿ Hold the P3 until the display shows
Ÿ Press start: automation will start in opening
Ÿ Press start when you want to begin slowing down.
Ÿ Arrived on the opening limit switch, automation will stop.
Ÿ Wait until the desired wait time and press start.
Ÿ The automation starts closing.
Ÿ Press start when you want to begin slowing down.
Ÿ Arrived on the opening limit switch, automation will stop.
NOTE: During this phase, the board detects the the current absorption curve,
for the obstacle detection.
appears on the display, then release.
appears
.
= Sliding door.
Min/Max
PS
01 ÷ 99
50Hz
PS
01 ÷ 99
50Hz
PS
01 ÷ 99
25Hz
PS
01 ÷ 99
25Hz
Pre-set
PF PL
25Hz 50Hz
PF PL
25Hz 50Hz
PF PL
15Hz 30Hz
PF PL
15Hz 30Hz