Oregon Scientific PE980 Manual De Usuario

ANYWEAR
Slim Pedometer
MODEL: PE980
USER MANUAL
EN
INTRODUCTION
Thank you for selecting the Oregon Scientifi c™ ANYWEAR
Slim Pedometer (PE980). The PE980 is a sensor type
pedometer that can detect steps in any dimension it is
carried. It is equipped with clock, alarm, 7-day memory, step
counter, distance counter and calorie counter functions.
IMPORTANT Do not immerse the pedometer in water.
CONTROL BUTTONS
1. SET: Enter Setting Mode; confi rm and move to next
setting option
2. DISP: Display calorie burned and distance walked;
increase values
3. MEM: Enter Memory Mode; decrease values
LCD
1 1
2
3
4
5
6
7
8
9
1. : Indicates calorie burned is displayed
2. : Indicates beep tone is Off
3. : Indicates battery power is low
4. Displays mode banners, number of steps, calorie
reading or distance walked
5. : Indicates alarm is On
6. : Indicates exercise timer is displayed
7. : Indicates on which day (1-7) before is the displayed
data recorded
8. / : 12 hour clock
9. Displays time or Setting Mode values
10. : Indicates distance walked is displayed
11. : Indicates you are in Memory Mode
12. : Indicates there is a following page
13. : Smart indicators to press the button beside
14. : Indicates step counter is On
15. : Indicates there is a previous page
16. : Calorie unit
17. : Distance unit (Miles / Kilometres)
18. : User's stride length unit (Centimetres / Inches)
19. : Weight unit (Pounds / Kilograms)
GETTING STARTED
ACTIVATE PEDOMETER (FIRST-TIME USE ONLY)
Press and hold any key until the screen is activated.
CARRYING THE PEDOMETER
The PE980 can be carried on the waist, around the neck or
in pockets and handbags by using the adjustable strap or
detachable clip provided.
SET TIME AND USER DATA
To effectively use the pedometer for calculating calorie
burned (based on step count and user body weight) and
distance walked (based on step count and length of user's
stride), you are advised to set the time and your user data in
the Setting Mode. Refer to Setting Mode in this manual.
IMPORTANT Remember to set the time and your user data
after every battery replacement.
BATTERY REPLACEMENT
The pedometer uses a CR2032 3V battery, which has
already been installed.
Indicates battery power is low.
To replace battery:
1. Use a small Phillips screwdriver to remove battery
compartment lid. Once opened, please keep the screws
in a safe place to avoid losing them.
2. Remove the old battery and insert the new one, matching
the polarities.
3. Replace the lid by screwing it back into place using a
Phillips screwdriver.
NOTE When the battery compartment is opened or battery
is replaced, all data in the pedometer will be reset.
OPERATION MODES
The PE980 has 3 modes of operation. The Main Mode is the
default display mode, which displays the current step count
and time. To enter other modes, press the buttons as shown
below.
MAIN MODE
In the Main Mode, you can:
• view the time and current step count (default), calorie
burned, distance walked and exercise time
• turn On or Off the step counter
To view the current calorie burned and distance
walked:
Press DISP. The display sequence is: calorie burned
and distance walked
is also displayed.
To turn the step counter On or Off:
In situations where you do not need to record step count, you
1
can turn Off the step counter.
2
Press and hold SET and MEM at the same time for 2
3
seconds until the following screen is displayed. To turn On seconds until the following screen is displayed. To turn On
the step counter, repeat the same action.
counter is On.
NOTE
• If the step counter is Off, there will be no step, calorie
and distance calculation or recording into memory.
1 10
• The current step count, calorie burned, distance walked,
11
and exercise timer will be reset automatically to zero at
12
midnight.
13
14
SETTING MODE
15
In the Setting Mode, you can set the time, alarm On/Off and
16
alarm time, user's weight and stride length, and beep tone
17
On/Off.
18
19
1. Press SET to enter the Setting Mode.
2. Wait for the setting option to fl ash, then press DISP
or MEM to set values. You can press and hold these
buttons to rapidly set the values.
3. Wait 3 seconds for the pedometer to automatically
confi rm and move to the next setting option. The setting
sequence is: stride length unit, stride length value,
weight unit, weight value, 12/24 time format, time (hour
and minute), alarm On/Off, alarm time (hour and minute)
(if alarm On is selected) and beep tone On/Off.
NOTE You can press SET to skip through settings.
REMARK Press any button to silence an activated alarm. If
not deactivated, the alarm will be activated at the same time
the following day.
MEMORY MODE
In the Memory Mode, you can view the records of your steps
and calories burned for the past 7 days.
1. Press MEM to enter the Memory Mode.
2. Press DISP or MEM to select which day to view.
NOTE
• When toggling between days, the record displayed will
be of the same category (either step count or calorie
burned).
• When viewing a day's record, the pedometer will
automatically toggle for 3 seconds between step count
and calorie burned display.
REMARK Toggle through all 7-day records to return to the
Main Mode.
To reset records:
You cannot reset the records manually. The pedometer is
designed to automatically reset the records.
SPECIFICATIONS
Real time clock
Step measurement
range
Distance measurement
range
User adjustable stride
length
Calorie measurement
range
Body weight range
Exercise timer range
Resolution
Power
Operating temperature
Storage temperature
PRECAUTIONS
To ensure you use your product correctly and safely, read
these warnings and the entire user manual before using the
product:
• Use a soft, slightly moistened cloth. Do not use abrasive
or corrosive cleaning agents, as these may cause
damage. Use lukewarm water and mild soap to clean
the device thoroughly after each training session. Never
use the product in hot water or store it when wet.
• Do not subject the product to excessive force, shock,
dust, temperature changes, or humidity. Never expose
the product to direct sunlight for extended periods. Such
treatment may result in malfunction.
• Do not tamper with the internal components. Doing
so will terminate the product warranty and may cause
damage. The main unit contains no user-serviceable
parts.
• Do not scratch hard objects against the LCD display as
this may cause damage.
. The exercise time with icon
indicates step
or
12 / 24 format with hour /
minute
0 – 99,999 steps
0 – 999.99 km
(0 – 621 miles) (0 – 621 miles)
28 – 152 cm
(11 – 60 inches) (11 – 60 inches)
0 – 99,999 kcal
29 – 154 kg
(64 – 340 pounds) (64 – 340 pounds)
99 hr 59 min 59 sec
0.1°C / 0.2°F
1 x CR2032 3V battery
-10°C to 40°C
(14°F to 104°F)
-20°C to 60°C
(-4°F to 140°F)
• Take precautions when handling all battery types.
• Remove the batteries whenever you are planning to
store the product for a long period of time.
• When replacing batteries, use new batteries as specifi ed
in this user manual.
• The product is a precision instrument. Never attempt
to take this device apart. Contact the retailer or our
customer service department if the product requires
servicing.
• Do not touch the exposed electronic circuitry, as there is
a danger of electric shock.
• Check all major functions if the device has not been
used for a long time. Maintain regular internal testing
and cleaning of your device. Have your device serviced
by an approved service centre annually.
• When disposing of this product, ensure it is collected
separately for special treatment and not as normal
household waste.
• Due to printing limitations, the displays shown in this
manual may differ from the actual display.
• The contents of this manual may not be reproduced
without the permission of the manufacturer.
NOTE The technical specifi cations for this product and the
contents of the user manual are subject to change without
notice.
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientifi c.com (www.oregonscientifi c.com) to learn more
about Oregon Scientifi c products.
If you're in the US and would like to contact our Customer
Care department directly, please visit:
www2.oregonscientifi c.com/service/support.asp www2.oregonscientifi c.com/service/support.asp
OR
Call 1-800-853-8883.
For international inquiries, please
oregonscientifi c.com/about/international.asp. oregonscientifi c.com/about/international.asp
EU-DECLARATION OF CONFORMITY
Hereby, Oregon Scientifi c, declares that this ANYWEAR
Slim Pedometer (Model: PE980) is in compliance with
EMC directive 89/336/CE. A copy of the signed and dated
Declaration of Conformity is available on request via our
Oregon Scientifi c Customer Service.
I
IN
G
di
co
m
co
di
ca
IM
P
1.
2.
3.
visit: www2.
L
1.
2.
3.
4.
5.
6.
7.
8.
9.
10
11
12
13
14
15
16
17
18
19
O
AC
Te
ac
IN
Il
ag
in
re
IM
Pe
ca
e
co
si
im
pr
I
de
S
Il
3V
So
1.
2.
3.
N
de
M
Il
La
pr
Pe
in