Troubleshooting - COX M7820 Guía Del Usario

4.

TROUBLESHOOTING

PROBLEM: Mode key does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
PROBLEM: Mode key blinks when you press a key, but
SOLUTION: Make sure you are aiming the remote control
PROBLEM: The remote control does not control home
SOLUTION: Try all listed codes for the device brand being
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume
PROBLEM:
SOLUTION: Due to RCA design (1983–1987), only the
PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required pressing
PROBLEM: Tried "Search For Your Code" and still could
SOLUTION: Try the "Search For Your Code" again after
M7820BP1.indd 18
Now, whenever you press VOL+, VOL–, or
MUTE, the volume will be controlled by your
auxiliary device.
alkaline batteries (see page 8).
home entertainment device does not respond.
at your home entertainment device and that
you are within 15-feet of the device you are
trying to control.
entertainment devices or commands are not
performing properly.
set up. Make sure all devices can be operated
with an infrared remote control.
combo units may require both a TV code and
a VCR code for full operation (see page 10).
Lock
(see previous page).
CH+ CH –
, , and
RCA TV.
original remote control will operate these
functions.
ENTER
to change channels, press
the remote control after entering a channel
number.
not find a working code.
clearing out the device key as follows: Press
SETUP
and hold
then release. Next enter
and release the mode key to be cleared twice.
LAST
do not work for your
until mode key blinks twice,
9 - 9 - 2
18
ENTER
on
. Then press
3/13/2007 3:54:01 PM