Setting The Sleep Timer; Using The Remote Control - Aiwa CA-DW257 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
GENERAL

SETTING THE SLEEP TIMER

The unit can be turned off automatically at a specified time.
1
Keep REPEAT/OSC/SLEEP pressed until "10"
flashes in the display.
2
Within 4 seconds, press r or t to
specify the time until the power is turned off.
Each time it is pressed, the time changes between 10
and 90 minutes in 10-minute steps.
Specified time
To check the time remaining until the power is turned
off
Repeat step 1 shown above. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press r or t
repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, c on the
deck will not be released. Press Z to release c.
8
ENGLISH
While the sleep timer works,
the dot keeps flashing.

USING THE REMOTE CONTROL

Buttons on the remote control and the main unit with identical
indications have the same functions.
To turn the power on
Press POWER to turn on the display.
When using the unit on the batteries, this button will not turn
the power on.
To turn the power off
Press POWER to turn off the display.
When one of the deck operation buttons is pressed, this
button will not turn the power off.
To use the FUNCTION button
Each time FUNCTION is pressed while the power is on, the
function is selected cyclically.
CD
* applicable when one of the deck operation buttons is
pressed
POWER
r, t
REPEAT/OSC / SLEEP
RADIO
* TAPE
FUNCTION

Publicidad

Tabla de contenido
loading

Tabla de contenido