Centrometal CentroPelet ZV16 Instrucciones Técnicas página 34

Norms and declarations of conformity
Our company declares that the stove conforms
to the following norms for the EC European Di-
rective labelling:
• 2014/30 UE (regulation EMCD) and following
amendments;
• 2014/35 UE (Low Voltage Directive) and following
amendments;
• 2011/65 UE (RoHS 2 directive);
• The New Rules of Construction Products
(CPR-Construction Products Regulation) No.
305/2011 regarding the construction world;
• For installations in Italy, please refer to UNI
10683/98 or following changes. For the water-
thermo-sanitary equipment, let the installer give
you the conformity declaration in compliance
with L. 37/2008. While installing the unit respect
the local, national and Europen rules;
• EN 55014-1; EN 55014-2; EN 61000-3-2; EN
61000-3-3; EN 60335-1; EN 60335-2-102; EN
62233, EN 50581.
Safety information
Please carefully read this use and maintenance
manual before installing and operating the stove!
If clarification is needed, please contact the
dealer or the Authorized Assistance Center.
• The pellet stove must only be operated in liv-
ing environments. This stove, being controlled
by an electronic board, permits a completely
automatic and controlled combustion; the ex-
change, in fact, regulates the lighting phase, 5
power levels and the shut down stage, guaran-
teeing the safe operation of the stove.
• The basket used for combustion allows most
of the ash produced by the combustion of the
pellets to fall into the collection compartment.
Nevertheless, check the basket daily, given
that not all pellets have high quality standards
(use only quality pellets recommended by the
manufacturer).
Responsibility
With the delivery of the present manual, we de-
cline all responsibility, both civil and penal, for
accidents deriving from the partial or total lack of
observance of the instructions contained herein.
We decline every responsibility derived from im-
proper use of the stove, from incorrect use by
34
the user, from unauthorized modifications and/or
repairs, from the use of replacement parts that
are not original for this model.
The manufacturer declines every civil or penal,
direct or indirect responsibility due to:
• Lack of maintenance;
• Failure to observe the instructions contained in
the manual;
• Use in non-conformity with the safety direc-
tives;
• Installation in non-conformity with the norms in
force in the country;
• Installation by unqualified
personnel;
• Modifications and repairs not authorized by
the manufacturer;
• Use of non-original replacement parts;
• Exceptional events.
• Use only wood pellets;
•Keep / store the pellets in a cool
dry place;
• Never pour pellets directly on the hearth;
• The thermostove
only be
6 mm diameter pellets of the type
recommended by the manufacturer;
• Before making the electrical connection
of the thermostove the discharge tubes
must be connected with the flue;
• The protective grill placed inside the
pellet container must never be removed;
• The environment where the stove is
installed must have a sufficient exchange
of air;
• It is forbidden to operate the thermostove
with the door open or the glass broken;
• Do not use the thermostove as an
incinerator; the thermostove should be
used only for the intended purpose;
• Any other use is considered improper
and therefore dangerous. Do not put in
the hopper other than wood pellets;
• When the thermostove is operating,
the surfaces, glass, handle and tubes
become very hot: during operation do
not touch these parts without adequate
protection;
• Keep the fuel and other inflammable
materials off the thermostove.
or untrained
fed with quality
must